Makita LS1019 Manual De Instrucciones página 27

1
► 1. Triangular rule 2. Saw blade 3. Top surface of
turn base
Check if the side of the blade squares with the turn base
surface once again. Loosen the screw on the pointer.
Align the pointer with 0° position in the bevel angle
scale and then tighten the screw.
45° bevel angle
NOTICE:
Before adjusting the 45° bevel angle,
finish 0° bevel angle adjustment.
Loosen the knob and fully tilt the carriage to the side
that you want to check. Check if the pointer indicates
the 45° position in the bevel angle scale.
If the pointer does not indicate the 45° position, align
it with 45° position by turning the adjusting bolt on the
opposite side of the bevel angle scale.
2
3
► 1. Left 45° adjusting bolt 2. Right 45° adjusting bolt
Adjusting the laser line position
For model LS1019L only
adjusting the laser line. Take extra care not to switch on
the tool during adjustment. Accidental start up of the tool
may result in serious personal injury.
beam. Direct eye exposure to the beam could cause
serious damage to your eyes.
NOTICE:
larly for accuracy.
NOTICE:
cause the laser line to be misaligned or may cause
damage to the laser, shortening its life.
NOTICE:
rized service center for any failure on the laser unit.
The movable range of laser line is decided by the range
adjustment screws on both sides. Perform following
procedures to alter the laser line position.
1.
2.
on the turn base. At this time, do not secure the work-
piece with a vise or similar securing device.
3.
the saw blade.
4.
secure the workpiece with the vertical vise so that the
workpiece does not move from the position you have
determined.
27 ENGLISH
1
WARNING:
The tool must be plugged in while
CAUTION:
Never look directly into the laser
Check the position of laser line regu-
Beware that impacts to the tool. It may
Have the tool repaired by a Makita autho-
Unplug the tool.
Draw a cutting line on the workpiece and place it
Lower the handle and align the cutting line with
Return the handle to the original position and
2