To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Remove the injector (D) and replace it with the
one suitable for the type of gas in use (see table
IT
ADJUSTING TOP BURNER PRIMARY AIR
To carry out this operation, proceed as follows.
GB
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
DE
3 - Undo the screws (C) and remove the control
panel (B).
FR
ES
English
B
A
B
A
at back of manual).
5 - After making the setting, seal the screw with
paint.
6 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
C
4 - Undo the screw (D) and lift the burner support
(E) as far as it will go.
5 - Tighten the screw (D) and restore the initial
conditions when the operation is complete.
E
C
- 22 -
D
IDM-39618301200.tif
D
IDM-39618301400.tif