Dräger X-plore Serie Instrucciones De Uso página 16

Tabelle 4: Particle filter
Type Col-
our
code
P White 1
Use
Handle the respiratory filter with care: do not knock or drop the fil-
ter!
Air from the filter can be warm and the filter housing may become
very hot during use. This shows that the filter is functioning correct-
ly.
 Only open the bag immediately before use. Do not bore into
the respiratory filter with sharp objects.
 The respiratory filter must be tightly connected to the fa-
cepiece.
Filters and facepieces are only to be used according to the
combinations listed (see Table 1).
Inserting two respiratory filters (unencapsulated particle filters,
particle filters, gas filters or combination filters)
(see Figure A)
 Position respiratory filter (1) – line markings opposite! – and
lock to the stop (2) by screwing the respiratory filter downward
until the stop is noticeable.
The respiratory filter is removed in the reverse way.
WARNING
!
Do not insert bayonet connector on one side only! Do not
jam respiratory filter when locking!
16
Catego- Filter effi-
ry ciency
Small
2 Medium
3 High
Limitations
Not against carcinogenic and
radioactive materials, air-
borne biological substances
of risk category 2 and 3 and
enzymes
Not against radioactive ma-
terials, airborne biological
substances of risk category 3
and enzymes
For Australia and New Zea-
land (SAI Global) the follow-
ing applies: P3 filters only
offer a P3 protection in com-
bination with full face masks.
With half masks they offer a
protection like P2 filters with
no limitation of use.