How To Use The Remote Control - Num'axes CANICOM 200 FIRST Manual De Instrucciones

CODING PROCEDURE FOR THE 1ST USE
To code, the remote control must be ready for use (battery in place).
1. Activate the receiver collar: approach the red mark located on the remote control until coming in
contact on red mark located on the receiver collar for 1 second.
2. Move the remote control away from the receiver collar.
3. Press the beeper button
synchronized with your remote control.
RE-CODING PROCEDURE (for all codings other than the 1st one)
To re-code, the remote control must be ready for use (battery in place).
1. Receiver collar in position « deactivate » (indicator light off): approach the red mark located on
the remote control until coming in contact on red mark located on the receiver collar for 6 seconds.
The indicator on the collar lights in fixed green, then flashes in red.
2. Move the remote control away from the receiver collar.
3. Press the beeper button
synchronized with your remote control.
N Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new
remote control from the CANICOM range.
Ref. § Re-coding procedure.

How to use the remote control

The CANICOM 200 FIRST remote control is designed to operate with 1 receiver collar.
O
button: beeper
If you press the « Beeper » button
this function: the beeper will continue to sound as long as you press the button.
The indicator light on the collar goes from flashing green to permanent green as long as you press the
button.
It is up to you to use the beeper depending on the way you want to train your dog. With the beeper you
can:
- send a sound to your dog when it is disobedient,
- draw its attention,...
Gb - 24
of the remote control. A sound beep is emitted, the receiver collar is then
of the remote control. A sound beep is emitted, the receiver is then
the receiver collar will emit sound signals. There is no time limit for