How To Use The Remote Control - Num'axes Canicom 250S Manual De Instrucciones

CODING PROCEDURE
1. Activate the remote control: press for 1 second the On/Off red button
2. Receiver collar in position « deactivated » (indicator off): approach the red indicator located on the
for 6 seconds. The indicator lights in fixed green, then flashes in red.
u Reprogram a receiver collar
Collar can be re-coded indefinitely, either with the same remote control, or with a new CANICOM
remote control. Ref. § coding procedure.
button: beeper
CANICOM 250S_Indice A_CANICOM 200 18/01/2021 11:51 Page20
It's very important to always use the beeper button in the same way in order not to disturb
your dog.
v F button: Flash stimulation
remote control.
remote control until coming in contact on red indicator located on the receiver collar, hold
v C button: Continuous stimulation
3. Move the remote control away from the receiver collar.
points located on the receiver collar, this will last for as long as the button is pressed but limited to
4. Press the button
8 seconds maximum.
with your remote control.

How to use the remote control

The CANICOM 250S remote control is designed to operate with 1 receiver collar.
v
If you press the « Beeper » button
this function: the beeper will continue to sound for as long as the button is pressed.
It's up to you to use the beeper depending on the way you want to train your dog. With the beeper button
you can:
- send a sound to your dog when it is disobedient,
- draw its attention,...
Press the «F» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
Press the «C» button to send a warning to your dog using stimulations transmitted by the two contact
of the remote control. A beep sound is emitted, the collar is then synchronized
Gb - 20
the receiver collar will emit sound signals. There is no time limit for
located on the side of the
( (