Checking/Replacing Battery Of Remote Control - Num'axes CANICOM 200 FIRST Manual De Instrucciones

Ocultar thumbs Ver también para CANICOM 200 FIRST:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

It's very important to always use the beeper in the same way in order not to disturb your dog.
O 1 to 5 buttons: continuous stimulations
Button 1: lowest stimulation / Button 5: strongest stimulation
Always start with the lowest level of stimulation.
Press the button 1, 2, 3, 4 or 5 to send a warning to your dog using stimulations transmitted by the two
contact points located on the receiver collar, the warning will last as long as you press the button but
limited to 8 seconds maximum. The indicator light on the collar goes from flashing green to permanent
red as long as you press the button.

Checking/replacing battery of remote control

To check the condition of the battery, observe the indicator light located on the front of the remote
control. If the light indicator flashes green 3 times when you press a button, the battery is weak.
Performance (radio range) of the remote control deteriorates as battery becomes weak. You
should soon replace the battery.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your
new purchased product. Other brands of batteries may not operate, or may not be completely
compatible with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Remove the old battery and replace it with a new one (3-V Lithium CR 2430) as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover.
- Remove the old battery.
- Insert the new battery (3-V lithium CR 2430) making sure the polarity "+" noted on the battery is
visible (ref. Diagram 5).
- Put the battery cover back in place and retighten the screw.
- Check the remote control operates correctly: Press a button: if the light indicator located on the front
of the remote control flashes green, the battery is properly inserted. If the indicator does not light,
remove the battery and check the polarity before inserting it once again (ref. Diagram 5: "+" noted on
the battery must be visible).
Gb - 25

Publicidad

Tabla de contenido
loading

Tabla de contenido