Threading The Needle Eye; Drawing Up The Bobbin Thread - Singer EM200 Manual De Instrucciones

T
HREADING THE
T N
HREADING THE EEDLE
CAUTION
To prevent accidents:
1. Keep fi ngers away from all moving parts. Special care
is required around the needle.
2. Do not lower the threader lever while machine is
operating.
NOTE:
The needle threader is used for needle sizes 11/80 and 14/90.
1. Lower the presser foot.
2. Check that the needle is raised to its highest position. If it is
not, raise needle by turning the handwheel toward you.
3. Lower the threader slowly and draw thread through thread
guide (a) and pull toward the right.
4. Lower the lever as far as it will go. The threader will turn
and the hook pin will go through the needle eye.
5. Draw the thread into the guide, ensuring that the thread is
under the hook pin.
6. Hold thread loosely and release the lever.
As the threader rotates back, the hook pin will pass through
the needle eye, forming a loop of thread.
7. Pull thread out about 10 cm (4 inches) through the needle
eye.
M
ACHINE
E
YE
D U B
RAWING P THE
This machine can start to sew without drawing up the bobbin
thread. If you want to start sewing with longer bobbin thread,
draw up the bobbin thread as follows.
1. Insert the bobbin into the bobbin holder as shown on page
13, but do not cut thread.
2. Raise the presser foot.
3. Hold upper thread loosely and turn hand wheel toward you
one complete revolution.
4. Pull upper thread lightly. Bobbin thread will come up in a
loop.
5. Pull both upper and bobbin threads about 10 cm (4 inches)
toward the back of presser foot.
6. Replace the bobbin cover. (See page 13)
15
T
OBBIN HREAD