Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Laser line
Marking
(pre-marked)
Fig. 21
NOTE:
Check and make sure on a periodic basis if the position of the laser line
is in order. As regards the checking method, draw a right-angle ink line
on the workpiece with the height of about 25/32" (20 mm) and the width of
5-29/32"(150 mm), and check that the laser line is in line with the ink line
[The deviation between the ink line and the laser line should be less than
the ink line width (0.5 mm)]. (Fig. 21)
PRACTICAL APPLICATIONS
WARNING:
* To avoid personal injury, never remove or place a workpiece on the
* Never place your limbs inside of the line next to warning sign while
Warning sign
Line
22
(3) After adjusting the position of the laser line, draw a
table while the tool is being operated.
the tool is being operated. This may cause hazardous conditions
(see Fig. 22).
right-angle ink line on the workpiece and align the ink
line with the laser line. When aligning the ink line,
slide the workpiece little by little and secure it by vise
at a position where the laser line overlaps with the
ink line. Work on the grooving again and check the
position of the laser line. If you wish to change the
laser line's position, make adjustments again
following the steps from (1) to (3).
Fig. 22
Warning sign
Line
Publicidad
Tabla de contenido
