Spark Arrester - Husqvarna CR 125 2010 Manual De Uso Y Mantenimiento

SPARK ARRESTER

The WR models are equipped with a U.S. Forest Service ap-
proved spark arrester for maximum efficienty and perform-
ance.
"SPARK ARRESTER" MAINTENANCE AND
CLEANOUT INSTRUCTIONS
Proceed as follows:
A: First turn counterclockwise fastening rear pin (A) then re-
move saddle, screws (1) and R.H. side panel (2).
B: Remove the two screws (3) fastening the muffler to the rear
frame. Extract the silencer from the union manifold to the ex-
haust pipe.
A
Note*: If silencer or exhaust are difficult to
remove, help to slide them apart by tap-
ping gently with a rubber or plastic ham-
mer.
C: remove the four screws (4) and the endcap (5) from si-
lencer's body;
D: examinate SPARK ARRESTER conditions and remove, if nec-
essary, carbon particles from the SPARK ARRESTER screen;
E: if necessary, inflate air on the SPARK ARRESTER screen, in
the opposite direction in respect of the exhausted gas flow;
F: assemble the front endcap on the silencer's body, mounting
the screws in the correct position, providing a tight connection
between endcap and silencer's body, using, if necessary, a sili-
cone paste;
G: re-assemble the silencer on motorbike.
Due to the SPARK ARRESTER position on the silencer, if you
need only to check the SPARK ARRESTER conditions you can:
A: disassemble the silencer from motorbike;
B: check SPARK ARRESTER conditions simply looking into the
silencer from front endcap opening;
C: if the check is positive, you can proceed in re-assembling
the silencer on the motorbike;
D: if the check is negative, proceed with the maintenance and
cleanout procedure.
1
2
63