End Of Life - STERWINS 40VCS2-34.1 Instrucciones De Montaje

FR
Problems
ES
PT
IT
Product does
EL
not start
PL
RU
KZ
Product does
not reach full
UA
power
Vibration
RO
or noise is
excessive
BR
Result is
EN
unsatisfactory
Product
suddenly stops
*Over current means "Self-protection". "Self-protection" mode is a degraded mode, limited in time (we
recommend a maximum duration of 5 minutes) during which the use of the product is made impossible
so that the product can recover its initial state.

9. END OF LIFE

Electrical products should not be discarded with household products. Used electrical products
must be collected separately and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.
Probable causes
Battery is not secure
Battery is not charged
Power/speed switch is in the
OFF position
Battery pack not properly
attached
On/off switch not set on ON
position
Chain brake is activated
Battery pack capacity too
low
Air vents are blocked
Bolts/nuts are loose
Saw chain is dull/damaged
Blunt saw chain
Saw chain not tensioned
properly
Battery pack discharged
Battery too hot
Product maybe over
current*
Solutions
To secure the battery pack,
make sure the latches on the
top of the battery pack snap
into place
Charge the battery pack
according to the instructions
included with your model
Press the on/off switch
Attach properly
Refer to chapter "Switching
on/off t"
Disengage the chain brake
(see section "Kickback brake")
Charge battery pack
Clean the air vents
Tighten bolts/nuts
Have it replaced with a new
one
Sharpen or re-place the saw
chain
Tension it properly
Remove and charge battery
pack
Remove battery pack and let it
cool down
Stop the product and wait for
3 minutes to restart
352
Qualifi cation
required
-
-
-
-
-
-
-
-