Replacing The Head Harness; Storage; Order List - Dräger FPS 7000 Instrucciones De Uso

Storage

4.4.8

Replacing the head harness

NOTICE
i i
A hair net can also be used instead of the head harness. The
hair net has the same clips as the head harness.
Replace head harness as described below (Figure J1 on page 3):
1. Pull the head harness away from the strap on the mask.
2. Push the clip on the head harness towards the visor.
Attach head harness to the mask as described below (Figure J2 on
page 3):
Put the clip onto the strap of the mask, then press the fastener.
Make sure that the tab on the strap locks firmly into the hole of the
clip.
5 Storage
After cleaning, put the facepiece into its bag or carrier box, make sure
that it will not deform, and use a storage space that is dry and free of
dust.
Storage temperature -15 °C to 25 °C.
Keep from direct sunlight or heat radiation.
Observe ISO 2230 and national regulations concerning storage,
cleaning and maintenance of rubber products.
30
6

Order list

Name and description
Accessories
Mask goggles FPS
Retrofitting set for mask goggles FPS
Inner mask size 1
Inner mask size 2
Inner mask size 3
Hair net
Dräger MS-COM, twisted cable,
ATEX-approved
Dräger MS-COM, straight cable,
not ATEX-approved
Dräger MS-COM, twisted cable,
not ATEX-approved
Harness for MS-COM
Cap RA/P MS-COM
Cap PE/ESA MS-COM
Carrying box FPS Box
Belt connection for FPS Box
Wall bracket for FPS Box
Carrier box Mabox 1
Carrier box Mabox 2
Protex mask box
(Certified by Dekra Exam)
Order code
R 56 230
R 56 799
R 56 472
R 56 470
R 56 471
R 56 197
R 35 085
R 35 024
R 35 025
R 56 846
R 56 821
R 56 822
R 56 380
R 56 883
R 56 882
R 53 680
R 54 610
R 54 939
Dräger FPS 7000