Brush Replacement; Troubleshooting; Failure To Start; Accessories - Delta ShopMaster S26-260L Manual De Instrucciones

BRUSH REPLACEMENT

The motor on this saw features externally accessible
brush assemblies that should be periodically checked for
wear. If the brushes need replaced, refer to Figure 25 and
proceed as follows.
1. Unplug the saw.
Failure to unplug the saw could result
in accidental starting causing serious
personal injury.
2. Using a screwdriver, carefully remove the brush
cap (A)
NOTE: Remove the cap slowly. The brush assembly is
spring-loaded and will pop out once the cap is removed.
3. Remove brush assembly (B).
4. Inspect both brushes. If either has less than 1/4 in.
length of carbon remaining, both brushes should be
replaced.
NOTE: Do not replace one side without replacing
the other.
5. Insert both brushes into the brush tube (C), making
sure the curvature of the brushes matches curvature
of motor. Brush assembly should move freely within
the tube.
6. Carefully replace the brush cap, being careful not to
strip the threads.
7. Tighten brush cap securely. Do not over tighten.

FAILURE TO START

If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the receptacle.
Also, check for blown fuses or open circuit breakers in your power supply line. If the saw still does not start, call
Company's Customer Care Center at 1-800-223-7278
For accessories please visit our Web Site www.DeltaMachinery.com for an online catalog or for the name or your nearest
supplier.
Since accessories other than those offered by Delta Power Equipment Corporation have not been
tested with this product, use of such accessories could be hazardous. For safest operation, only
SHOPMASTER accessories recommended or approved by Delta Power Equipment Corporation.
PARTS, SERVICE OR WARRANTY ASSISTANCE
All SHOPMASTER Machines and accessories are manufactured to high quality standards and are serviced by a network
®
of DELTA Authorized Service Centers. To obtain additional information regarding your product or to obtain parts,
service, warranty assistance, or the location of the nearest service center, please call 1-800-223-7278.
MAINTENANCE

TROUBLESHOOTING

ACCESSORIES

22
A
C
B
FIGURE 25