Step 2 - Connect To A Gas Supply Line (Gas Dryer Only) - Haier GDE480BW Manual Para El Usuario

Secadoras de ropa a gas y eléctricas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 2 - CONNECT TO A GAS SUPPLY LINE
(GAS DRYER ONLY)
NOTE: Do not connect the dryer to an LP gas line without fi rst converting the
dyer with a conversion kit. An LP conversion kit must be installed by a qualifi ed
technician.
NOTE: Apply a pipe-joint compound that that is resistant to the action of LP gas to
all males threads. Do not use plumber's tape.
1. Turn the gas supply o by moving the shuto valve to the closed position.
Closed Valve
Open Valve
2. Disconnect and discard old fl exible gas connector. Replace with a new
CSA(AGA) approved fl exible gas connector.
3. Remove the shipping cap from the gas inlet pipe at the rear of the dryer.
4. Connect a
" NPT elbow to the gas inlet pipe on the dryer. Then connect a fl are
adapter to the elbow.
IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.
Gas Inlet Pipe on
the Dryer
" NPT Elbow
" NPT Flare Adapter
5. Connect the dryer to the gas supply line with a fl exible gas connector.
Flexible Gas Connector
6. Tighten the fl exible gas connector using two adjustable wrenches.
18
A
A
B
B
C
A

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Gdg480bwCgde480bw

Tabla de contenido