Installation Instructions; Risk Of Fire; Tools Needed; Additional Parts Required - Haier GDE480BW Manual Para El Usuario

INSTALLATION INSTRUCTIONS

Risk of Fire

Clothes dryer installation must be performed by a qualified installer.
Install the clothes dryer according to the manufacturer's instructions
and local codes.
To reduce the risk of severe injury or death, follow all installation
instructions.
IMPORTANT: When discarding or storing your old clothes dryer, remove the door.

TOOLS NEEDED

•
Phillips Screwdriver
•
Flat-Blade Screwdriver
•
Channel-Lock Adjustable Pliers
•
½" Open-End Wrench
•
Carpenter's Level
•
Measuring Tape (12 ft [3.7 m] min.)

ADDITIONAL PARTS REQUIRED

•
4" (10.2 cm) Rigid or Flexible Metal Exhaust Ducting
•
Vent Clamps
•
Duct Tape
•
Power Cord (U.S. Electric Dryer Only)
- A power supply cord kit must be purchased to meet local electrical codes.
The dryer must use a 3 or 4-wire NEMA 14-30 or 10-30 type SRDT or ST
(as required) power supply cord rated at 120/240 volt AC minimum,
30 amp, with 3 open-end spade lug connectors with upturned ends or
closed loop connectors and marked for use with clothes dryers.
- UL Listed Strain Relief
•
Gas Hookup Parts (Gas Dryer Only)
- " NPT Elbow
- " NPT Flare Adapter Fitting
- " Flexible Gas Connector
- Pipe-Joint Compound
•
Mobile Home Installation Kit (Gas Dryer for Mobile Home Only)
6
WARNING
For gas installations only:
•
Pipe Wrench
•
2 Adjustable Wrenches