Special Safety Instructions; Technical Data - Rothenberger ROGROOVER 1 - 12 Instrucciones De Uso

• This could otherwise lead to accidents or injury
1.2

Special safety instructions

About the grooving machine
• The grooving machine has been manufactured for making grooves in tubes and pipes.In or-
der to handle the machine follow the instructions in this manual. Any other uses increase the
risk of injury occurring.
• Keep your hands away from the rotating parts. Do not wear gloves which could loosen when
operating the unit. Your fingers could get caught by these rotating parts.
• Keep the protective cover in its position. Do not operate the grooving machine if you have re-
moved the cover. If the rotating parts are exposed body parts could get caught thus causing
serious injury.
• Install the grooving machine on a flat, even surface. Ensure that the machine and its supports
are stable. This prevents the unit from overturning.
• Do not wear loose clothing. Keep sleeves and jackets closed. Do not extend your body over
the machine or the tube. Your clothes could get caught in the tube and cause serious injury.
• Fix the tubes correctly using tube supports.
• Whilst operating the machine keep your hands away from the end of the tube. This prevents
the risk of injury from the sharp edges or chips.
2

Technical Data

Max. permitted diameter ............................. 12" (325 mm)
Min. permitted diameter .............................. 1" (33 mm)
Max. permitted tube thickness .................... 10 mm
Max. working pressure ................................ 7850 kg
Max. hydraulic cylinder pressure ................. 40 MPa
Oil tank capacity ......................................... 150 ml
Lathe screw speed ...................................... 36 min
Electric motor
1500001351................................................
1500001352................................................
1500001353................................................
General dimensions (W x D x H ) ................ 474 x 910 x 635
Weight ........................................................ 32 lb
Standard equipment:
Grooving machine with drive shaft and set of three grooving rollers. Drive shaft and set of groov-
ing rollers, for diameters 1" - 11/2"; 2" - 6" and 8" - 12".
Tube stabiliser:
The tube stabiliser is available as a support accessory for grooving.
18
-1
1500 Watt–230 V–50 Hz
1500 Watt–230 V–60 Hz
1500 Watt–110 V–50 Hz
ENGLISH