Fitting The Footrests - Invacare Aquatec Ocean VIP Manual Del Usuario

Fitting the removable handle
Unscrew the two cross slotted cheese head screws D from the
1.
removable handle B and remove the lower part of the fastening
clamp E.
Guide the removable handle with the wire A for activating
2.
the pneumatic springs upwards through the gap between the
backrest cover and the belt locks F.
3. Place the removable handle with the top part of the fastening
clamp onto the handle of the backrest so that the hand lever C
points to the right.
4. Fix the removable handle to the tubular frame using the bottom
part of the fastening clamp and the two cross slotted cheese
head screws. Tighten the screws lightly.
5. Align the removable handle as shown in the figure above.
6. Tighten the two cross slotted cheese head screws.
1563142-A

Fitting the footrests

1. Push the footrest A with the footplate D inwards into the guide
H on the seat frame I until the groove B catches the pin on
the clip G. The footrest can no longer be turned to the sides.
The assembly procedure is the same for the right and the
left footrests.
Adjusting the height of the footrests
Pull up the footrest A slightly.
1.
Pull out the clip G and put it in again at the required position.
2.
Pull out the footrest slightly further if necessary.
3. Push down the footrest until the groove B catches the pin of
the clip.
4. Set the other footrest to the same height as described.
Setup
13