BQS BNOFIX DS15 Manual De Instrucciones página 23

1. Release the harness buckle (7) (fig. 15).
2. Press the harness adjuster button (13) while pulling
the part of the harness straps that cross the chest in
order to loosen them fig. 2). Do not pull the shoulder
protectors.
3. Place the child in the safety seat.
4. make sure the child's back rests firmly against the
back of the safety seat.
5. Bring the two clasps together (5) and join them
before inserting them into the harness buckle (7).
You should hear a click (fig. 16).
6. Pull the harness adjustment strap (14) in order to tighten
and adjust it correctly to the child's body (fig. 17).
IMPORTANT! The part of the harness straps that crosses
the abdomen should be placed as low as possible on
the child's hip.
7. Pull down on the shoulder protectors (3) to ensure
they are properly in place.
For the safety of the child the following checks should
be made before every trip:
• The safety seat is firmly installed in the vehicle.
• The straps are not twisted.
• The safety seat straps are firmly fastened around the
child's body, without squashing it.
(10)
• The shoulder straps are correctly adjusted and
not twisted.
44
fig. 15 fig. 16
clIck
Harness
(14)
fig. 17
adjust strap.
14
• The shoulder protectors (3) are on a level with the
child's shoulders.
(5)
• The clasps are correctly inserted into the belt
buckle (6).
BNO FIX 0+123
6. CAR SEAT FORWARD-FACING INSTALLATION.
GROUP 1 (OPTIONAL)
GROUP 1 only. From 9 months
NOTICE
to 4 years approx. (9 - 18 kg)
1. Ensure that the seat is not in number 4 reclined
position. Pull the lever (15) forward and adjust the
angle of recline to position 1, 2, or 3 without releasing
the lever. Release the lever when the seat is in the
desired position (fig. 18).
wARnInG! once the car seat is installed, if another
recline position is selected, you should repeat the car
seat installation steps described below to ensure a
proper installation s in this new position.
NOTICE: This car seat offers different installation options
(installation table, chapter 2) WITH or WITHOUT Isoclick
Fix ® connectors.
• For a car seat installation using Isoclick Fix
connectors and vehicle's belt, please start from
section 6.1.
• For a car seat installation using only the vehicle´s belt,
please start from section 6.2.
6.1 Connecting the Isoclick Fix ® arms in a
rearward-facing installation (optional).
1. Make sure the Isoclick Fix arms are displayed to install
the car seat forward facing (group 1/2/3) (fig. 9).
2. Place the seat in the back seat of the vehicle in the
direction of travel.
www.babyqs.com
fig. 18 fig. 19
1 2 3 4
fig. 20
®
(11) Abdominal
fig. 21
belt guides
(group
0+/1/2/3).
CLICK
11
CLICK
OK
16
11
45