Standards Conformity - Bowers & Wilkins Panorama Manual Del Propietário

Standards conformity

North America
1. PRODUCT
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this product may not cause harmful interference, and
(2) this product must accept any interference received,
including interference that may cause undesired
operation.
2. IMPORTANT NOTICE: DO NOT MODIFY THIS
PRODUCT
This product, when installed as indicated in the
instructions contained in this manual, meets FCC
requirements. Modification not expressly approved by
Bower and Wilkins may void your authority, granted by
the FCC, to use the product.
3. NOTE
This product has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation.
This product generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this product does cause harmful
interference to radio or television reception, which can
be determined by disconnecting Panorama from the
mains, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the product into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the local retailer authorized to distribute
this type of product or an experienced radio/TV
technician for help.
For Canadian Customers
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
Europe
This product complies with the EU Electro-Magnetic
Compatibility (EMC) Directive 2004/108/EC, in
pursuance of which the following standards have
been applied:
EN 55013 EN 61000-6-1
EN 55020 EN 61000-4-2
EN 61000-6-3 EN 61000-4-3
EN 61000-3-2 EN 61000-4-4
EN 61000-3-3 EN 61000-4-5
EN 61000-4-6
EN 61000-4-11
and complies with the EU Low Voltage Directive
2006/95/EC, in pursuance of which the following
standard has been applied:
EN 60065
This declaration attests that the manufacturing process
quality control and product documentation accord with
the need to assure continued compliance.
The attention of the user is drawn to any special
measures regarding the use of this equipment that may
be detailed in the owner's manual.
Signed
G Edwards
Executive Vice President, Operations
B&W Group Ltd.
151