AD Instruments AD2817C Manual De Usuario página 98

AD2817C Operation Manual
point to twinkle, then press ▲ or ▼ key to move it.
f) If multiple needs modifying, press
to twinkle, then press ▲ or ▼ key to modify multiple.
g) After setting, press
it. Or press
m
modification.
h) At the status of non-data modification, press ESC key to exit.
4) High and low limits of primary parameters setup (BIN 1L BIN1H BIN2L BIN2H
BIN3L BIN3H)
At limit setup page, select item of BIN1L, BIN1H, BIN2L, BIN2H, BIN3L, BIN3H through
or key, to set limits of bins.
At absolute tolerance mode, high and low limits of primary parameters are displayed in the
similar way of nominal value with unit and multiple; at percentage tolerance mode,
corresponding data are displayed in the form of percentage without unit and multiple. For
example, at percentage tolerance mode, low limit of BIN1 is -5.000, then it will be
displayed as -5%, as shown in Figure 4-24 and 4-25.
Figure 4-24 Data display at absolute tolerance mode
Figure 4-25 Data display at percentage tolerance
5) High and low limits of primary parameters setup (SEC L, SEC H)
There is no nominal value for secondary parameter, so only absolute limit of non-deviation
type can be set.
At limit setup page, select SEC L or SEC H through
and high limit of secondary parameter, as shown in Figure 4-26.
or
ENTER key to ensure the modification, or ESC key to cancel
n M p
Figure 4-23 Nominal value setup
33
key to select the unit and multiple
directly, select rate and confirm data
k
or key, then set low limit