Maintenance - edenox DPN-28 Manual De Instrucciones

3.3 OPERATION MODES AND CONFIGURATION OF THE DEVICE.
A thermostat control is used to adjust the temperature of the plate heating distributor(Figure
1, 'A'). It is steplessly variable within a range of 30°C to 90°C. The control lamp (Figure 1, 'B') for the
heating elements switches on each time the temperature in the distributor chamber falls a few
degrees.
With the plate distributors, plates of specific diameters can be safely stored: the DPN-28 and
DPC are designed for the diameters of 180-280 mm, and the DPN-34 and DPC-34 for 240-340 mm.
They have an adjustable six-step system of three rails protecting the plates from sliding off the
platform. In order to adjust the distributor to the plates of smaller diameter, raise a rail approximately
1 cm and turn it to the platform (clockwise). In order to adjust the distributor to the plates of larger
diameter, raise a rail approximately 1 cm and turn it from the platform (counter-clockwise). Repeat
this with each rail, making sure the extent of adjustment is the same each time so that the plates can
be located centrally and safely.

4. MAINTENANCE

4.1 General safety requirements.
4.2 Cleaning and general maintenance.
4.3 Disposal of the device.
4.1 GENERAL SAFETY REQUIREMENTS.
All outer steel surfaces and all surfaces of the moving platform need to be cleaned daily using a
small amount of detergent and lukewarm water. After being cleaned, the surfaces should be rinsed
with cold water and dried.
Do not clean acid-resistant steel surfaces with scrapers or wire cleansers, since they can
scratch the surfaces.
If the device is not going to be used for a long time, cover its surfaces, particularly the
operating surfaces, with a thin coat of Vaseline or a preservative that may come into contact with
food.
IMPORTANT!!!
Do not clean the plate heating distributor with a water jet, since this might damage the electrical and
electronic components ensuring the proper operation of the device.
The device may be maintained only by trained
and specialized personnel using suitable
protective clothing (shoes, gloves, goggles,
etc), tools, instruments, and accessories.
7
edenox.com
Before using or repairing the device, read the
instruction manual containing proper
procedures and safety information.
ENGLISH