Changing The Interchangeable Die Sets; Removing Die Sets; Installing Die Sets - GBC Magnapunch 2.0 Manual De Instalación Y Funcionamiento

C i
hanGinG the nteRChanGeaBle
d s
ie ets
Your Magnapunch 2.0 offers the convenience
of interchangeable Die Sets, allowing you to
economically punch documents for a wide variety of
binding styles.
R d s
eMovinG ie ets
To remove Die Sets from the Magnapunch 2.0:
The interchangeable Die Set slot of the Magnapunch
2.0 is located on the right front side of the
Magnapunch 2.0. If a Die Set is already installed in
your Magnapunch 2.0, you can easily remove the Die
Set.
1. Grab the Die Set handle by placing your palm on
the front and wrapping your fingers behind the
handle (located on the right side of the Die Set).
Figure 24. Die Set Partially Pulled Out.
2. Securely grasp the handle and tug firmly.
3. Continue pulling on the handle until the Die Set
is fully removed. Support the Die Set with both
hands.
4. Properly store the removed Die Set (away from
dust, dirt, falls, etc.).
Helpful Hint: The GBC Die Set Storage Holder is
an excellent way to store your interchangeable Die
Sets for the Magnapunch 2.0. This holder securely
holds several Die Sets, protecting them from dirt,
Page 6-6
Magnapunch 2.0 – Installation and Operating Instructions
dust, and potential damage. Contact your GBC sales
representative for information on obtaining a Die Set
Storage Holder.
i
•
•
To install a Die Set:
1.
2.
3.
Die Set handle.
Note: If the Die Set is not properly inserted into the
Magnapunch 2.0 and locked into place, the LCD
displays an error.
d s
nstallinG ie ets
CAUTIONS:
Possible pinch point hazard. When installing Die
Sets into your Magnapunch 2.0, always keep
fingers and body parts out of the Magnapunch
2.0's Die Set slot and away from all areas of the
Die Set except for the finger groove in the Die
Set's handle. Failure to observe these precautions
may result in injury.
Possible Die Set damage. Make certain that all
punch pins are fully and properly seated in the Die
Set before inserting the Die Set. Failure to ensure
that all punch pins are fully seated could result in
damage to the Die Set and Magnapunch 2.0.
Grab the Die Set handle by placing your palm on
the front and wrapping your fingers behind the
handle (located on the right side of the Die Set).
Refer to "Figure 24. Die Set Partially Pulled Out."
Carefully align the leading edges of the Die
Set's support rails with the leading edges of the
Magnapunch 2.0's guide rails.
Using your fingers in the Die Set's handle, firmly
push the Die Set into the Magnapunch 2.0's Die
Set slot. You will hear a click when the automatic
locking mechanism engages. This mechanism
securely holds the Die Set during punching
operations.