Testing The Job - GBC Magnapunch 2.0 Manual De Instalación Y Funcionamiento

Magnapunch 2.0 – Installation and Operating Instructions
Because of its open-end Punch Throat design, you
can use your Magnapunch 2.0 to punch sheet sizes
that are larger than the maximum width of paper that
can be punched in one operation.
Note: Multiple steps are required to punch these
larger sheets of paper. Some experimentation will
be required to determine the correct position for the
Edge Guide.
t J
estinG the oB
Before beginning a punching job, test your
Magnapunch 2.0's variable settings by punching
five to ten sheets of paper that match the exact size
of the actual materials to be bound. This will allow
you to make any adjustments to the Magnapunch
2.0 without wasting the documents to be bound.
The following steps indicate how to test your
Magnapunch 2.0 for proper Edge Guide alignment.
To test hole alignment for your job:
1. On the HOME screen, set the PUNCH mode to
Foot Pedal to avoid accidently cycling the punch.
Figure 32. Home Screen with Foot Pedal Selected.
1. Insert five pieces of paper of the same size as
the document to be punched completely into the
Punching Throat.
2. Slide the paper to the left until it touches the
Edge Guide.
3. Hold the test sheets in place and depress the
Foot Pedal to punch the test sheets.
4. To check the Edge Guide alignment, do one of
the following.
a. For all punching patterns
Remove the punched sheets from the
Punch Throat. Take one punched sheet,
fold it so that the holes overlap, and confirm
the space between the edge of the media
and the first hole is equal to the space
between the edge of the media and the last
hole. If the spaces are not equal, slightly
adjust the Edge Guide. If the margin is
except SureBind:
greater on the left, move the Edge Guide
to the right. Then punch another five test
sheets and re-check the spacings. Repeat
this process as needed until the spacings
are equal.
Figure 33. Checking Edge Guide Alignment.
b. For SureBind: Remove the punched sheets
from the Punch Throat. Fold the media
in half as represented in
at the two holes closest to the center or
"V" of the fold. The holes on each side
should line up with each other if the Edge
Guide is positioned properly. If this is not
correct, slightly adjust the Edge Guide,
punch another two to three test sheets, and
re-check the spacings. Repeat this process
as needed until the spacings are correct.
Note: Before making any adjustments to the
Magnapunch 2.0's variable settings, make sure the
PUNCH mode on the HOME screen is set to Foot
Pedal to prevent accidently cycling the punch.
Figure 33. Look
Page 6-9