Punching Operation; Punching The Job - GBC Magnapunch 2.0 Manual De Instalación Y Funcionamiento

p o
UnChinG peRation
p J
UnChinG the oB
Note: Before making any adjustments to the
Magnapunch 2.0's variable settings, make sure the
PUNCH mode on the HOME screen is set to Foot
Pedal to prevent accidently cycling the punch.
After installing the correct Die Set in your
Magnapunch 2.0, and following the setup
instructions in "Job Setup"
are ready to begin punching. The following sections
indicate how to activate the Magnapunch 2.0. Read
these sections completely to become familiar with
unique Die Set features and helpful punching tips.
Note: The Punching Margin is fixed for most Die Sets
and no margin adjustments are required. Refer to the
next section to set up the CombBinding Die with the
three position adjustable back gauge.
For CombBinding Only
The CombBind Die Set is equipped with a variable
punching margin (also called depth of punch)
device. This feature allows you to choose from three
punching margins for your plastic comb bound
documents. The punching margins offered by your
Magnapunch 2.0 are listed in the following table.
Table 2. Punching Margin Settings
Punching Punching
Margin Margin Depth
Setting
0.10 in. (2.5 mm) ≤ 5/16 in. (7.9 mm)
1 (Small)
2 (Medium) 0.14 in. (3.6 mm) 3/8 to 9/16 in. (9.5
0.19 in. (4.8 mm) ≥ 5/8 in. (15.9 mm)
3 (Large)
The Control Lever for setting the punching margin is
located inside of the plastic binding Die Set's handle.
The punching margin is controlled by pushing in or
pulling out this lever.
Page 6-10
and "Testing the Job", you
Best Plastic
Binding Elements
Diameter:
mm to 14.3 mm)
Magnapunch 2.0 – Installation and Operating Instructions
To change the punching margin for plastic
binding Die Sets:
1. Do one of the following.
• For Punching Margin 3, firmly grasp the
Control Lever and fully push it in to the Die
Set. The Control Lever will click into place
when this setting is reached.
• For Punching Margin Setting 2, firmly grasp
the Control Lever and pull gently outward.
The Control Lever will click into place as this
position is reached.
• For Punching Margin Setting 1, continue to
pull gently outward. The Control Lever will
click into place when this position is reached.
Figure 34. Die Set Partially Pulled Out.