GBC Magnapunch 2.0 Manual De Instalación Y Funcionamiento página 28

6. Press NEXT. The LCD screen displays an image
similar to the ruler on the Die Set and shows
where the left Edge Guide should be placed.
Figure 28. Set Side Screen.
7. Slide the left Edge Guide to that position and
press NEXT.
NOTE: When positioning the left Edge Guide, the
right edge of the clear pointer should be placed on
the dot.
Figure 29. Setting Edge Guide On the Dot.
8. Following the instructions on the LCD UI, remove
the Die Set from the Magnapunch 2.0, ensure
all pins are in place and then remove the pins
identified on the LCD UI. This will eliminate
punches at the edge of your document.
NOTE: Each pin is labeled with a pin number on the
Die Set ruler.
Page 6-8
Magnapunch 2.0 – Installation and Operating Instructions
Pointer on dot.
Figure 30. Pin Configuration Screen.
9. Reinsert the Die Set into the Magnapunch 2.0.
To leverage Die Set markings for common paper
sizes:
Common media sizes are displayed on the Die Set
label and have a line with a dot at the end identifying
where to set the left Edge Guide.
1. Insert the proper Die Set for the punch pattern
required for the job.
2. On the HOME screen, set the PUNCH mode to
foot pedal to avoid accidently cycling the punch.
Figure 31. Home Screen with Foot Pedal Selected.
3. Slide the left Edge Guide to the proper position
based on your media size.
NOTE: when positioning the left Edge Guide, the
right edge of the clear pointer should be placed on
the dot. See "Figure 29. Setting Edge Guide On the
Dot."
4. Insert your media to be punched and place
against the left Edge Guide. Look at the Die Set
pins and identify any that need to be removed to
avoid punching the edge of your document.
5. Remove the Die Set and take out the pins if
necessary.
6. Reinsert the Die Set.
7. Set the Punch mode back to
Sheet Sizes Larger Than the Maximum
Punch Width
Trigger if needed.