Punching Tips; Paper; Plastic Covers; Chip Drawer - GBC Magnapunch 2.0 Manual De Instalación Y Funcionamiento

p t
UnChinG ips
This section provides additional information about
punching paper and proper operation of the
Magnapunch 2.0.
p
apeR
The Magnapunch 2.0 is capable of punching any
paper from onion skin bond to cardboard stock.
Because there are variations in the thicknesses and
types of materials that can be punched, it is difficult
to define the exact maximum number of sheets that
can be punched at one time.
For typical maximum punching capacities for the
Magnapunch 2.0 using 20 lb. (75 g/m 2 ) bond sheets,
refer to "Table 3. Punching
Punching too many sheets at a time can damage
the Magnapunch 2.0. It also affects the quality of the
punched holes. This hole quality degradation varies
by the paper stock and personal esthetic standards.
Generally, reducing the number of sheets punched
per cycle improves the quality and appearance of the
holes.
Page 6-12
Capacity".
Magnapunch 2.0 – Installation and Operating Instructions
p C
lastiC
You can use the Magnapunch 2.0 to punch plastic
covers. Be sure to observe the following guidelines
to prevent damage to the Magnapunch 2.0 and Die
Sets.
• Punch no more than two or three covers per
cycle.
• Separate each plastic cover with a sheet of 20
lb. (75 g/m 2 ) paper before punching.
C d
hip RaWeR
The Chip drawer is located at the front of the
Magnapunch 2.0 base. The Chip Drawer should be
periodically emptied to avoid jamming and damage
to the Magnapunch 2.0 and Die Sets.
Figure 38.
oveRs
Chip Drawer Opened.