AD Instruments AD1062P Manual De Usuario página 206

13. The volt value of CH1.
14. The volt value of CH2.
The ALT Trigger menu (Type edge)(Page 2/2)
The Alternative menu table (Type edge)(Page 2/2)
Menu Setting
2/2
ON
HF Reject
OFF
50%
2/2
The ALT Trigger menu (Type Pulse)(Page 1/2)
The Alternative menu table (Trigger Type: Pulse Page 1/2)
Menu Setting
CH1
Channel
CH2
Type EdgePulse
+more
+Less
+Equal
When
-more
-Less
-Equal
Figure 2-31 The ALT Trigger menu
Description
Back to the previous menu page
Reject high frequency signals or not
Set the trigger level to the center of the signal.
Back to the previous menu page.
Figure 2-32 The ALT Tirgger menu
Description
Set trigger mode for Channel 1.
Set trigger mode for Channel 2.
Set Edge/Pulse Trigger as the trigger type.
+Pulse width more than
+Pulse width less than
+Pulse width equal to
-Pulse width more than
-Pulse width less than
-Pulse width equal toTo select pulse condition.
40