AD Instruments AD1062P Manual De Usuario página 244

Figure 4-9 AC Current Measurement for 600 mA
3) Press the FI key once and AC will display on the bottom of the screen.
4) Insert the black lead into the COM banana jack input and the red lead into the I0A
banana jack input.
5) Connect the red and black leads to the measured point and the AC current value of
the measured point will be displayed on the screen.
6) Press F2 to return to 600 mA measurement.
Then, the screen will look like the following figure 4-10.
Figure 4-I0 AC Current Measurement for I0A
Taking a Relative Measurement
A currently measured result relative to the defined reference value is displayed in a rela-
tive measurement.
The following example shows how to take a relative measurement. At first, it is required
to acquire a reference value.
I) Press the R key.
2) Insert the black lead into the COM banana jack input and the red lead into the Vl lC
banana jack input.
3) Connect the red and black test leads to the resistor. The resistor value is shown on
the screen in Ohm.
4) When the reading leveling off, press F1 key and then IIl ,is displayed on the top of
77