Setting Procedure - Waeco MagicSpeed MS880 Instrucciones De Montaje

MagicSpeed MS880
10

Setting procedure

The procedure remaining after installation and connection depends on the
type of connection.
For CAN bus connections (connection to the CAN bus) you must perform
the following steps:
 To synchronise the system for CAN bus connection,
see chapter "Synchronising with a CAN-bus connection" on page 65
 To check the system connection, see chapter "Testing MagicSpeed (diag-
nosis mode)" on page 70
 To test the system: see chapter "Testing functions" on page 75
For analogue connections (analogue speed signal) you must perform the
following steps:
 To synchronise the system for analogue connection,
see chapter "Synchronising with an analogue connection" on page 68
 Perform pedal test,
see chapter "Adjusting the accelerator pedal manually" on page 69
 To check the system connection, see chapter "Testing MagicSpeed (diag-
nosis mode)" on page 70
 Start automatic mode,
see chapter "Starting automatic mode" on page 73
 Set the control sensitivity (if necessary),
see "Setting the control sensitivity (GAIN mode)" in the diagnostics
manual on our homepage
 To test the system: see chapter "Testing functions" on page 75
EN
Setting procedure
63