Waeco MagicSpeed MS880 Instrucciones De Montaje página 66

Synchronising with a CAN-bus connection
Step 2 (accelerator pedal test)
➤ Press the accelerator pedal slowly as far as it will go and let it return the
same way slowly as far as the neutral position.
✓ While this happens,you will hear acoustic signals which signify the various
positions:
– Neutral position (idle):
– 50 % position:
– 100 % position:
I
NOTE
 If a low-pitched signal does not sound or you hear a high-
pitched signal during the pedal test, this step has failed and
programming must be repeated from step 1.
 Some accelerator pedals do not provide sufficient electric sig-
nals when fully pressed down. In this case, only press the
pedal approx. three-quarters of the way down in step 2, as oth-
erwise the test will not be successful.
Step 3 (quit synchronisation)
➤ Switch the ignition off.
✓ Normally, your cruise control should be ideally preset for your vehicle.
Refer to the figure on page 67 for a summary of the CAN bus connection and
pedal test.
66
...
...
...
MagicSpeed MS880
EN