Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
tUrnkey loCkoUt systeM
(dart 2 with tUrnkey oPtion/dart 3)
:
important note
when storing a bicycle or fork upside
.
can collect above the turnkey assembly
upon returning the bicycle
initial performance of the turnkey system may be less than optimal
,
'
'
performance
return the fork to
open
position and cycle the fork through its travel
'
'
information on returning your fork to
open
position
The TurnKey lockout system offers a two position 'on/off' lockout. Using either the crown mounted
adjuster or an optional PopLoc Remote, the rider is able to choose between maximum compliance and
fork movement (when the lockout is 'off') and minimal compliance and fork movement (when the lockout
is 'on').
The TurnKey lockout is 'off' when either the crown mounted adjuster (or remote spool) is in the full
counterclockwise position or the PopLoc Remote lever returns to the 'unlock' position. The lockout turns
'on' as the rider rotates the crown mounted adjuster clockwise or by pressing forward on the optional
Poploc Remote located on the handlebar.
:
'
'
note
when the turnkey lockout is
on
and the fork encounters a considerable input force
'
'
will
blowoff
and allow the fork to move into its travel to absorb the input force
and remain in its lockout state until either another force is encountered or the rider turns the adjuster
'
'
.
to the
off
position
TurnKey Lockout
TurnKey two position
' On - Off ' lockout
Off
On
Off position
On position
Crown mounted adjuster
PopLoc Remote
6
Dart User Manual
-
,
down or on its side
oil sealed in the upper tube
/
fork to a normal riding position
.
to quickly return the fork to proper
10-20
times
,
!
keep reading
,
the lockout
.
the fork will return
Off = maximum fork movement
On = minimum fork movement
On
Off
PopLoc Remote
(optional)
PopLoc Adjust Remote
Fig. 2
95-401-306-000 Rev D
Dart User Manual
oil tUning (dart 2)
Changing the HydraCoil oil in your fork will alter its rebound characteristics. Rebound is the return stroke
of the fork in opposition to compression. To slow the rebound of your fork (greater damping), replace the
stock 5 wt. oil with a heavier weight suspension oil. For faster rebound (less damping), replace the stock
,
oil with a lighter weight suspension oil. For further information on oil volumes and adding oil to your fork,
visit our website at www.rockshox.com or contact your local dealer or distributor.
.
for
MaintenanCe
To maintain the high performance, safety, and long life of your fork, periodic maintenance is required. If
you ride in extreme conditions, maintenance should be performed more frequently.
:
note
we recommend this service be performed by a qualified bicycle mechanic
information or instructions
dealer or distributor
Clean dirt and debris from upper tubes
Inspect upper tubes for scratches
Lubricate dust seals/tubes
Check to caps, brake posts, and shaft bolts for proper torque
Check air pressure
Remove lowers, clean/inspect bushings, and change oil bath
Change oil in Motion Control System
Clean and lubricate Air U-Turn/Dual Air/Air Assist assembly/Solo
Air
Clean and lubricate coil spring or coil U-Turn spring assembly
Clean and lubricate PopLoc cable and housing
:
notes
=
e
every ride
numeric values represent hours of riding time
increase service intervals based on rider weight
©SRAM Corporation • 007
,
.
.
visit our website at www
rockshox
com or contact your local rockshox
.
torque tightening Values
Top Caps
65 in-lb (7.3 Nm)
Brake Posts
80 in-lb (9.0 Nm)
Shaft Bolts
60 in-lb (6.8 Nm)
U-Turn Adjuster Knob Screw
1 in-lb (1.4 Nm)
serViCe interVals
.
,
aggressive riding style
English
.
to obtain service
dart 1/2
dart 3
E
E
E
E
10
10
5
5
*
*
*
50
*
*
*
*
100
100
*
*
/
,
.
conditions
inclement weather and racing
7
Publicidad
Tabla de contenido
