Controls - CGC RYAN Serie Manual Del Operador

FIGURE 17
1. Literature Mounting Plate
30. Attach the cutting blade using six (6) 5/16–24 x 1"
grade 8 screws, lockwashers and nuts. Torque at-
taching hardware to 30 ft.–lbs. (40.7 N m).
NOTICE
S Use only the special grade 8 cap screws provided.
Screws below grade 8 will not withstand the recom-
mended torque requirements.
31. Attach throttle control cable to handle using clip
(loose on cable), one (1) #10–24 x 1/2" screw and
lockwasher.
32. Install one (1) 1/2" flangelock nut to the guard sup-
port rod.

CONTROLS

Engine Switch Turn to "ON" position to start
engine. Turn to "OFF" position
to stop engine.
Clutch Control Engages or releases drive belt
Lever and applies brake action to
drive belt when pulled FIRMLY
to rear. See Figure 18, item 1.
Throttle Control Speeds up or slows down
engine. See Figure 18, item 2.
Operator Presence With clutch control engaged,
Control engine will stop if operator
presence lever is not depressed.
See Figure 18, item 3.
1
Blade Depth
Control Lever
Blade Angle
Locking Lever
Blade Depth
Control Locking
Lever
Depth Gauge
1
3
FIGURE 18
1. Clutch Control Lever
2. Throttle Control
3. Operator Presence Control
Raises or lowers cutting blade.
See Figure 19, item 1.
Adjusts cutting angle of blade.
See Figure 19, item 3.
Locking lever holds blade
depth control lever in desired
position. See Figure 19, item 2.
Allows resetting of blade depth
to the previous cutting height.
1
4
FIGURE 19
1. Blade Depth Control Lever
2. Blade Depth Control Locking Lever
3. Blade Angle Control Locking Lever
4. Depth Gauge
2
4901
2
3 4900
9