Serial Number And Model Number Plate; Operation - CGC RYAN Serie Manual Del Operador

SERIAL NUMBER
MODEL NUMBER PLATE
The serial number and model number plate on the Jr.
Sodcutter is pictured below. The plate is located on top
the gearcase to the rear of the unit, just in front of the han-
dlebar mounting location.
CGC
COMMERCIAL GROUNDS CARE, INC.
MODEL NUMBER
SERIAL NUMBER
JOHNSON CREEK, WI
FIGURE 1
1. Serial Number/Model Number Plate
OPE R ATION TR AINING VIDE O:
4131316 - JR. Sodcutter Operator Training, English
SET±UP
WARNING
!
To prevent serious injury, ALWAYS wear eye
protection and stand clear when cutting band-
ing. Banding is under tension and may snap
back when cut.
NEVER disable the operator presence control by
altering or modifying it in any way.
The Sodcutter is very heavy, to prevent serious
injury, use an adequate lifting device (i.e., hoist,
fork lift, etc.) to remove from shipping pallet.
1. Remove and discard banding attaching Jr. Sodcutter
to pallet.
2. Remove and discard reinforced tape securing han-
dlebar and clutch control assembly to pallet.
3. Using an adequate lifting device, remove Jr. Sodcut-
ter from shipping pallet.
4. Remove hardware bag and empty contents onto a
surface where they will not be misplaced or lost.
5. Loosen, remove and retain hardware securing guard
to side of unit. Remove guard to allow access to idler
assembly and brake band components.
6. Slide adjustment end of brake band over the guard
support rod as shown in Figure 2.
AND
MADE IN U.S.A.
3
2
FIGURE 2
1. Brake Band
2. Cotter Pin Holes
3. Adjustment Screw
7. Insert one (1) cotter pin on each side of brake band,
using the two (2) cotter pin holes shown in Figure 2.
BE SURE the heads of the cotter pins are on the
pulley side of the support rod to prevent interference
between cotter pin and belt.
NOTICE
To prevent loss of gear lube from bottom hole in gear
case, tip unit forward until lifting handle on front of
unit is resting on the ground.
8. Remove and retain the upper two (2) screws a d
lockwashers from the rear of the gear case. Loosen
the lower screw far enough to allow the handle bar
to slide behind the screw and washer.
9. Apply Permatex gasket compound or an equivalent to
the three screws (in step 9). Attach handlebar support
to crankcase as shown in Figure 3 and attach the ªLº
bracket shown in Figure 4. BE SURE slotted side of ªLº
bracket is facing toward the large pulley (See Fig. 4).
2
3
FIGURE 3
1. Crankcase Screws
2. Handlebar Support
3. Guard Support Rod
1
5159
1
5159
5