Attaching The Lid Handle; Securing The Lid Stopper; Assembling The Side Shelf - Pit Boss PB820SC Instrucciones Y Recetas

front. Add a cabinet door bezel on the screw, then hand-tighten the
screw (from the rear) into the cabinet door handle. Continue to secure
the handle by inserting a screw into the other side and tightening.
• Repeat same installation for second cabinet door handle.
7. MOUNTING THE CABINET DOORS TO THE CART
Installation:
• Align the left cabinet door with the front of the cart. Insert the bottom
pin into the pivot hole on the left side of the bottom shelf, then push
down on the locking-loaded top pin, and lock into the hole on the
main barrel brace.
IMPORTANT: The cabinet door should swing freely once installed, and
line up with the door stopper and door magnet. If unlevel, ensure
the top and bottom pins of the cabinet door are inserted correctly.
• Repeat same installation for second cabinet door on the right side.

8. ATTACHING THE LID HANDLE

Parts Required:
1 x Lid Handle (#8)
2 x Lid Handle Bezel (#7)
Installation:
• Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw so that it protrudes to the outside. Add a
bezel on the screw, then hand-tighten the screw (from the inside) into
the lid handle. Repeat same installation for other end of lid handle.

9. SECURING THE LID STOPPER

Parts Required:
Lid Stopper (#3)
1 x
Installation:
• Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.

10. ASSEMBLING THE SIDE SHELF

Parts Required:
1 x Side Shelf (#15)
Tool Hook (#17)
4 x
Side Shelf Handle (#16)
1 x
Bottle Opener (#18)
1 x
Installation:
• Turn the side shelf upside down. On the edge of the side shelf with four
holes, install the tool hooks into each hole along the edge. Tool hooks
will secure to the self-clinching nut that is pre-mounted on the inside.
• Next, remove the pre-mounted screws from the side shelf handle. On the
short side with two holes, hand-tighten the screw (from the inside) into
the handle. Repeat for the other end of the handle. Note illustration 10A.
7
8
9
10A
10B
9