Installation Section; Safety And Disposal Standards - Fuba ODE8510 T2 STEALTH Manual Del Usuario

1 Installation Section

1.1 Safety and disposal standards

For a safe use of the appliance and for your own safety, please read the following recommendation concerning the safety
measures.
POWER SUPPLY

Use the supplied power supply unit and connect the device exclusively to a 230V~ 50Hz mains socket.

Do not remove the cover. Voltages higher than the power source may be present inside the unit and may endanger your safety.
High tension is present even when the appliance is in standby mode, and before working on the receiver you must disconnect it
from the mains. Non-authorized removal will void the warranty!
POWER CORD

Before installing the unit, check that the power wire is intact paying particular attention to the point where it enters the power
outlet and the point where it comes out of the receiver. If the cable is damaged, do not plug it into the device and contact a local
service center.

Install the power cord so as not to crush it with objects placed on top or next to it. Also avoid positioning the cord near areas where
it could be accidentally stepped on, torn, or otherwise damaged.

If the cable is damaged in any way, carefully disconnect the receiver from the power supply and contact a specialist or a Service
Centre for repair.
LIQUIDS

Keep the product away from any kind of liquid. Do not place objects filled with fluids such as vases, humidifiers and the likes on the
device which should not be installed in places where it may come in contact with sprays or drops of water or in environments with
high humidity where condensation may occur.

Should the receiver accidentally come in contact with any liquid, immediately remove the plug from the socket. DO NOT TOUCH the
device with your hands before it has been disconnected.
SMALL ITEMS

Keep coins or other small items away from the receiver. Objects that fall within the device, through the slits or air vents, may
cause serious damage.
CLEANING

Prior to cleaning, disconnect the device from the power outlet.

To clean the outside of the receiver, use a soft, dry, or slightly moistened cloth. Avoid using chemicals or solvents.
VENTILATION

Wherever the device is installed, make sure there is good air circulation to ensure sufficient heat dissipation and to avoid
overheating.

A minimum distance of 10cm from both sides and a distance of 15 cm above the device should be provided in order to allow proper
ventilation.

The air vents must be kept clear from any obstructions such as newspapers, tablecloths, upholstery fabrics, etc.Avoid placing the
receivernear heatsources(radiators, stoves, etc.) oron top of otherheat-producing equipment (VCRs, audio amplifiers, etc.).

Avoid installing the receive near heat sources (radiators, stoves, etc.) or over other devices that produce heat (amplifiers,
videorecorders, etc.)
ATTENTION

Keep this product out of reach of children.

The packaging plastic bags can be dangerous. To avoid suffocation, keep the bags out of the reach of children.

Do not expose the receiver or the remote control to direct sunlight.

The appliance must be placed on a solid, secure base.

Connect the device to the power supply only after completing the installation.
DISPOSAL

The crossed out trash bin symbol indicates that this product cannot be dispersed into the environment or thrown in the
town's mixed municipal waste. Those who do not respect this are liable to punishment according to local legislation.

A proper disposal of the appliance enables you to avoid potential damage to the environment and human health, as
well as to facilitate the recycling of components and materials contained in it, saving energy and resources.

The manufacturer provides a system for recovery (RAEE or REEE) of the product which is collected separately and provides
treatment systems using equipment in accordance with current provisions.

Take the unusable product (and any accessories, including the battery) to a recycling center authorized to handle electrical and
electronic equipment waste, as it cannot be pooled with other waste. Alternatively, you can return the used or obsolete device to a
distributor while replacing it with a new equivalent product or, as for all home appliances smaller than 25cm, you can leave the
device free of charge with a distributor.
ODE8510 T2 STEALTH
1