Troubleshooting Guide - Fuba ODE8510 T2 STEALTH Manual Del Usuario

Fuba

5 Troubleshooting guide

SYMPTOM
The LED on the external IR sensor will
not turn on.
Lack of signal.
Absence of sound and/or images.
The remote control does not work.
The adjustments made in the menu
are not saved.
The program information
displayed.
The timer does not start or function
properly.
The receiver does not respond to the
action buttons.
The table continues on next page ...
14
POSSIBLE CAUSE
The receiver is disconnected from the
mains power supply.
The power supply is plugged in but it
doesn't work anyway.
The external IR sensor is not connected
or is not inserted properly.
Antenna cable not connected to the
receiver.
Damaged antenna system.
The tuned channel is not broadcasting or
is obsolete.
Audio volume low or mute.
The receiver is in standby.
TV is turned off or positioned on the
wrong channel.
HDMI cable is not connected to your TV
or is damaged.
The receiver's HDMI resolution is not
compatible with the resolution of the
connected screen.
You are trying to view an outdated or
incompatible encoded channel.
The external IR sensor is not entered or
it is not connected properly.
IR sensor and remote control are unable
to communicate with each other.
The remote control is in the wrong mode.
Batteries not inserted or exhausted.
Batteries inserted with incorrect polarity.
The remote fell and some components
are damaged.
No confirmation after changing the
settings.
The program
is not
transmit information about the event.
The receiver clock is not set correctly.
The broadcaster transmits incorrect data
and/or date.
The receiver's clock is set incorrectly.
The receiver is temporarily blocked.
Current channel sends inappropriate
data that are blocking the receiver.
Problems with the remote.
Check that the receiver is plugged in.
Make sure the power supply is working.
ATTENTION
Insert the plug of the IR sensor in the
receiver by pressing it gently up as far as
it will go.
Connect the antenna wire to the receiver.
Verify the integrity of your system
(antenna, coaxial cable, signal distribution
devices, etc.). It is advisable to have
qualified personnel verify the installation.
Change channels and/or upgrade or
reinstall the channel list (para. 3.3).
Increase the level of audio volume of the
receiver and the TV.
Switch the receiver on.
Turn on the TV screen and/or place it on
the correct audio-video channel.
Restore the audio-video connection.
Try connecting another screen/TV via
HDMI.
Change channels and/or upgrade or
reinstall the channel list (para. 3.3).
Insert the plug of the IR sensor in the
receiver by pressing it gently up as far as
it will go.
Remove any obstructions and point the
remote control at the IR sensor.
Press the STB to gain control of the
receiver.
Insert the batteries or replace them.
Insert
direction. Follow the signs inside the
battery compartment.
Contact your dealer to purchase a new
remote control.
After each edit, press the appropriate
button to confirm/save.
concerned does not
Adjust the receiver clock (para. 3.4.3).
Adjust the receiver clock (para. 3.4.3).
Disconnect the receiver power supply and
reconnect it after a few seconds.
Disconnect the antenna cable, restart the
receiver, switch channels, then reconnect
the antenna.
See relevant suggestions listed in this
table.
REMEDY
: risk of electric shock!
the batteries in the correct