Optional Extras; Troubleshooting; Maintenance And Care - Metz MECABLITZ 44 AF-3 N Manual De Instrucciones

Ocultar thumbs Ver también para MECABLITZ 44 AF-3 N:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

7. Optional extras

No guarantee is given for malfunctions and damage to the mecablitz
caused by the use of accessories from other manufacturers!
• Wide-angle diffuser 20 mm
(Item No. 000044217)
For full illumination in conjunction with lenses of 20 mm focal length
onward. The maximum flash range is reduced by the factor 1.4 due to the
corresponding loss of light.
• Colour filter set 44-32
(Item No. 00004432A)
Consists of 4 colour filters to achieve special lighting effects, plus a clear fil-
ter to hold colour foils in any colour.
• Mecabounce 44-90
(Item No. 000044900)
A diffuser to achieve soft illumination in the simplest possible manner. The
effect is very impressive because the pictures are given a very soft atmos-
phere. Facial colours are rendered more naturally. However, loss of light
halves the maximum flash range.
• Bounce diffuser 54-23
(Item No. 000054236)
The soft directed light diminishes dense shadows.

8. Troubleshooting

Should the LC display indicate meaningless information or should the flash
unit not work properly in the individual modes, then switch off the mecablitz
for about 10 seconds by its main switch. Check the camera settings and find
out if the flash unit's foot is correctly mounted in the camera's accessory shoe.
The mecablitz must operate properly when it is switched on again. Contact
your local dealer should this not be the case.

9. Maintenance and care

Remove any grime and dust with a soft, dry or silicon-treated cloth. Never
use detergents that could damage plastic parts.
Forming the flash capacitor
The flash capacitor incorporated in the flash unit undergoes a physical change
when the flash unit is not switched on for prolonged periods of time. For this
reason it is necessary to switch on the mecablitz for approx. 10 minutes every
3 months (see 2.4!). The batteries must supply sufficient power for flash readi-
ness to be indicated within 1 minute after the mecablitz was switched on.
81

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mecablitz 44 af-4 n

Tabla de contenido