Inflation; Inflating Procedure - Corghi A 2025 LL Manual De Uso

31
- Turn the turntable clockwise until the up-
per bead is completely mounted.
NOTE: Ensure that the bead passes over
the tail of the head.
- Tilt the column backwards, release the wheel
and remove it from the tyre changer.

INFLATION

WARNING
Inflation is a notoriously hazardous
operation. Inflation must be carried
out in accordance with the following
instructions.
WARNING
Noise levels may reach 85 dB(A) during
this operation. Hearing protection is
recommended.
WARNING
During bead insertion and inflation,
the use of goggles and ear protectors
is recommended
DANGER
Although it does have a pressure limiting
function, the machine cannot guarantee
54
sufficient protection if the tyre explodes
during inflation. Failure to comply with
the instructions below will render tyre
inflation dangerous.
DANGER
NEVER exceed the pressure value re-
commended by the tyre manufacturer.
Tyres may explode if inflated beyond
these limits or their structure may be se-
riously damaged without any immediately
visible signs. KEEP YOUR HANDS AND
BODY AWAY FROM THE TYRE DURING
INFLATION. Avoid distractions during
this operation and check the tyre pres-
sure often to prevent over-inflation. A
bursting tyre can cause serious injuries
or even death.

Inflating procedure

The machine has a pedal for inflating the
tyre and a pressure gauge for reading the
tyre pressure.
- Release the wheel from the sliding clamps
on the table top.
- Bring the horizontal arm to the fully ex-
tended position.
- Lower the vertical rod until it touches
the rim.
- Lock the horizontal arm and the vertical rod
in the positions described above fig. 32.
- Connect the Doyfe connector on the air
hose to the valve stem.
Inflate the tyre by operating the proper
pedal at short intervals; check the pres-
sure gauge frequently to make sure
that the pressure NEVER exceeds the
maximum pressure specified by the tyre
manufacturer.
Operator's manual A 2025 LL