Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

➥ Replace the cock.
Air escapes from cock.
➥ Replace the cock or column tilting
cylinder.
Air leaks from the vertical and
horizontal arm locking cock
Valve seal damaged.
➥ Replace the handle cock.
Clamping arm cylinders leak air
Faulty piston or gaskets.
➥ Replace the pistons and gaskets.
The column tilts violently or
too slowly
Incorrect outlet regulator setting.
➥ Adjust the outlet regulators.
Hare: speed increase.
Tortoise: speed reduction.
Tyre pressure gauge needle
fails to return to 0
Pressure gauge faulty or damaged.
➥ Replace the pressure gauge.
WARNING
The "Spare parts" handbook does not
authorise the user to carry out any work
on the machine other than the operations
specifically described in the User Manual,
and is only intended to enable the user
to provide the technical assistance ser-
vice with precise information in order to
minimise response times.
Operator's manual A 2025 LL

MAINTENANCE

WARNING
CORGHI declines all responsibility in the
event of claims resulting from the use of
non-original spare parts or accessories.
WARNING
Do not attempt to modify the pressure set-
tings for relief valves or the pressure limiter
for any reason whatsoever. The manufactur-
er declines all liability for damage resulting
from tampering with these valves.
WARNING
Before adjusting or servicing the machine,
disconnect the electricity and compressed
air supplies and ensure that all moving parts
are suitably immobilised.
WARNING
Do not remove or alter any part of this ma-
chine (only technical assistance personnel
is permitted to do so).
DANGER
When the machine is disconnected from
the air supply, the devices bearing the sign
shown above may remain pressurised.
The purpose of the regulator filter unit plus
lubricator (FRL) is to filter the air, adjust the
pressure and lubricate it.
The "FRL" unit supports a maximum input
pressure of 18 bar and has an adjustment
range of 0.5 to 10 bar. The setting may be
modified by pulling the handle out and
then turning. After adjusting, return the
handle to the locked position by pushing
down (fig.35a).
The lubricant flow-rate is adjusted by turning
the screw on part "L", (fig.35b); normally this
unit is precalibrated to a pressure of 10Bar,
UK
57

Publicidad

Tabla de contenido
loading

Tabla de contenido