Operating Conditions Under Which This Product May Be Safely Used; Scope; Hazardous Rating Location Of Facility Where It Is To Be Installed; System Including Tb8-Xx-Xx-Xx-03 Transmitter - CiDRA SONARtrac GVF-100 Manual De Instalación

7
OPERATING CONDITIONS UNDER WHICH THIS
PRODUCT MAY BE SAFELY USED
7.1

Scope

These are the criteria under which it is safe to install the ATEX Zone 2
rated products:
7.2 Hazardous Rating Location of Facility Where It Is To Be
Installed
7.2.1

System including TB8-xx-xx-xx-03 Transmitter

The TB8-xx-xx-xx-03 Transmitter must be installed in an area that is
rated as Non-Hazardous or ATEX Zone 2. The SH-xxx-xx-xA-xxx-03
Sensor Head must be installed in an area that is rated as Non-
Hazardous or ATEX Zone 2. The cable connecting the TB8-xx-xx-xx-
03 Transmitter and the SH-xxx-xx-xA-xxx-03 Sensor must be routed
through areas that are rated Non-Hazardous or ATEX Zone 2 and
must not exceed 114 meters (375 feet) in length.
The cable between the Transmitter and Sensor Head should be
installed per the applicable electric codes of that jurisdiction and/or per
the guidance of EN 60079-14 for this Zone 2 intrinsically safe [ic]
(energy limited) associated apparatus field wiring. The Sensor 1 and
Sensor 2 inputs are also intrinsically safe [ic] (energy limited)
associated apparatus field wiring.
None of the other wiring is intrinsically safe field wiring. This wiring
must be wired per the applicable electric codes of that jurisdiction
and/or per the guidance of EN 60079-14 wiring techniques for Zone 2
incendive wiring if any part of that wiring is in a Zone 2 area. Cable
glands used should preserve the IP 55 and ATEX rating of the
enclosure. Refer to paragraph 8.3.1 for information on the selection of
cable glands.
7.2.2

System including TB8-xx-xx-xx-04 Transmitter

The TB8-xx-xx-xx-04 Transmitter must be installed in an area that is
rated as Non-Hazardous, or ATEX Zone 2. All of its interfaces must
be treated as incendive and wired per the applicable electric codes of
that jurisdiction and/or per the guidance of EN 60079-14 wiring
techniques for Zone 2 incendive wiring if any part of the wiring is in a
20909-01C Rev 06
The system comprised of: Transmitter TB8-xx-xx-xx-03 with Sensor
Head SH-xxx-xx-xA-xxx-03, or
The system comprised of: Standalone Transmitter TB8-xx-xx-xx-04
with separately certified sensor head
Page 7-1