Dealer Service And Adjustment; Dealer Service Introduction; Critical Maintenance Tips; Cleaning - Sunrise Medical Zippie ZM-310 BC Manual De Instrucciones

Z I PP I E Z M- 3 10 Z I PP I E Z M- 3 10
The owner of this chair is responsible for making sure that it has been setup and adjusted by a trained
service professional under the advice of a Healthcare Professional. Service or adjustments should only
be done with the advice of a Healthcare Professional. Always use parts and accessories that have been
recommended and approved by Sunrise Medical when servicing this chair.
A. DEALER SERVICE INTRODUCTION
1. At least once per year, this chair should have a complete inspection, safety check, and regular
service made by an Authorized Dealer.
2. If you have discovered a worn, bent, or damaged part, repair or replace them with recommend-
ed parts before returning this chair to service..
3. All major maintenance and repair work should be done by the Authorized Dealer.
B. CRITICAL MAINTENANCE TIPS
1. Torque settings:
A torque setting is the optimum tightening which should be made on a particular fastener. It is impor-
tant to use proper torque settings where specified. When not specified, torque settings should be set
at a minimum of 60 in-lbs.
2. Dealer Service and Adjustment Reference materials:
Go to www.sunrisemedical.com for parts manuals, instruction sheets, and instructional videos that will
aid in the repair of the Quickie/Zippie Family of wheelchairs.
C. CLEANING
1. Paint Finish
a. Clean the painted surfaces with mild soap or detergent.
b. Protect the paint with a coat of non-abrasive auto wax.
2. Axles and Moving Parts
a. Clean around axles and moving parts with a slightly damp (not wet) cloth.
b. Wipe off or blow away any fluff, dust or dirt on axles or moving parts.
c. DO NOT USE 3 in 1 oil, or WD-40 ® for lubrication. Only use Teflon based Lubricant when
working on this wheelchair.
D. ADJUSTMENT NOTES
1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your chair. This makes the
steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-strength fasteners and may
have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert to help prevent loosen-
ing.
• Only use screws, bolts and nuts provided by Sunrise.
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause damage to chair parts.
3. If bolts or screws become loose, tighten them as soon as you can. Loose bolts or
screws can cause damage to other chair parts causing them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers when you reassemble
parts.
127899 Rev. C
WARNING
WARNING
28
XI. DEALER SERVICE & ADJUSTMENT
TOOLS YOU WILL NEED
1. Imperial Hex key set
2. Metric Hex key set
3. Imperial Open-end Wrench set
4. Metric Open-end Wrench set
5. Torque wrench
6. Imperial Hex bit Socket set
7. Metric Hex bit Socket set
8. Phillips and Flat screwdrivers