Av Menu Items - JVC KW-NT1 Manual De Instrucciones

AV menu items

Menu items
Fader/Balance
Cursor
Equalizer
Subwoofer/HPF
Adaptive Volume
Telephone Muting *
Amplifier Gain
1
* The TEL MUTING lead connection is required. (☞ Installation/Connection Manual)
Selectable settings
Fader: Adjust the front and rear speaker output balance.
• F6 to R6; Initial 0
– When using a two-speaker system, set the fader to the center (0).
Balance: Adjust the left and right speaker output balance.
• L6 to R6; Initial 0
Press [5/∞/2/3 ] or drag the cursor to adjust.
• To set the fader and balance to the center (0), press [Center].
Flat/Hard Rock/R&B/Pop/Jazz/Dance/Country/Reggae/Classic/
User1/User2/User3 (☞ page 67)
Adjust the subwoofer output level, Cross Over, and High Pass Filter.
Press [Enter] to adjust each setting.
• Level: Adjust the subwoofer output level.
–6 to +8; Initial 0
• Cross Over: Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
80Hz, 120Hz, 150Hz
• High Pass Filter:
On: Select when the subwoofer is connected.
Through: Select when the subwoofer is not connected.
When this function is activated, the System automatically increases the
volume level (both for guidance and audio) as the car speeds up.
Off, Min, Mid, Max
1
Muting1, Muting2: Select either one which mutes the sounds while
using the cellular phone.
Off: Cancels.
You can change the maximum volume level of this unit.
High: VOL 0 to 20 (for guidance)/VOL 00 to 50 (for audio)
Low: VOL 0 to 15 (for guidance)/VOL 00 to 30 (for audio)
(Select this if the peak power of the speakers is less than 50 W.)
Off: Deactivates the built-in amplifier (VOL 0 to 20 for guidance/VOL 00
to 50 for audio.)
68