Palazzetti IDRO Instrucciones De Uso página 53

ROOM TEMP.
)
Stove operating parameters can be set in all
three phases.
7KH DGMXVWPHQW SDUDPHWHUV DUH RQO\ DFWLYH LQ
the work phase. In effect, the "START" and "OFF"
SKDVHV DUH DGMXVWHG DXWRPDWLFDOO\ +HQFH WKH
POWER DGMXVWPHQW LQ WKH ³START" and "OFF"
phases will define what the value of the two
parameters will be in the "WORK" phase.
7.3.2 START PHASE (lighting the stove)
To switch-on the stove keep the ON key pressed
for a few seconds.
The following message will appear onto the display
"WAIT FLAME".
This phase is automatic and is completely managed
by the stove. Consequently it is not possible to vary
any parameter (Fig. 7.3.2-1).
'XULQJ WKLV SKDVH WKH ÀDPH LV SURGXFHG DQG WKH
stove will reach the operating mode.
The following message will appear onto the display
"FLAME PRESENT".
The stove will automatically move onto the work
SKDVH LI WKH WHPSHUDWXUH LV VXI¿FLHQW WR RSHUDWH
correctly otherwise the NO IGNITION ALARM
ACTIVE will be signalled (par. 7.7.1).
)
Automatic lighting: the stove is equipped with
an automatic device which enables the pellets
to be lit without using other traditional lighters.
If there are any unpleasant smells or fumes they
are caused by the evaporation or drying of some
of the materials used.
This phenomenon will last for several days but will
gradually disappear.
7.4 WORK PHASE
Once the stove is lit, the word "WORK" appears on
the display. 'XULQJ WKLV SKDVH WKH VWRYH DGMXVWV
itself automatically according to the values
set for stove power, room temperature and water
temperature. "WORK" stays permanently on the
display and the following parameters are also
displayed in sequence at regular intervals:
POWER (value that can be set between A, 1 and 5).
,W GH¿QHV WKH SRZHU DW ZKLFK WKH VWRYH ZRUNV )LJ
  WR DGMXVW
When the word "POWER appears press the
to increase the value or
P = A DXWRPDWLF VWRYH DGMXVWPHQW
If this is activated, it indicates automatic stove
DGMXVWPHQW EDVHG RQ WKH WKHUPRVWDW VHW WHPSHUDWXUH
(in the menù operation:
TEMP.). The power of the smoke fan is selected
autonomously.
Upon reaching room temperature
and/or WATER TEMP.) the display will show in
the case of:
cod. 00 477 1490 - 11/2013 - PN - Italy
USE AND MAINTENANCE
key
to reduce it.
SET ROOM T. o WATER
(ROOM TEMP.
Fig. 7.3.2-1
Fig. 7.3.2-2
Fig. 7.4-1
53/172