Assembly; Unpacking And Assembling The Wheels - Kemper SmartMaster Manual De Uso

5 Assembly

WARNING
Serious injury can be caused when mounting the exhaust arm as
a result of the pretensioning of the coil springs employed. In the
event of improper handling, the support frame may move
unexpectedly and cause severe facial injuries or crush fingers!
NOTE
The end-user of the SmartMaster may only entrust the assembly of the
device on their own to persons who are familiar with the task.
Two people are needed to assemble the device.

5.1 Unpacking and assembling the wheels

• Remove the small boxes from the large outer packaging and put them to one side.
• Now lift off the large outer packing upwards.
• The SmartMaster stands on a cardboard base and is bolted to the pallet with
two metal brackets. Cut open the corners of the cardboard bottom with a knife,
so that you can fold the sides down. Loosen the screws of the metal angle
brackets and also remove the two larger screws in order to completely
dismantle the load restraints.
• In the small box there are two large rear wheels with pre-assembled axle and
two smaller steering castors with brakes (front wheels).The two screws for
fastening are also already pre-assembled/inserted on the steering castors.
Also here are two flaps to cover the rear wheels.
• There is a handle bar on the rear side of the device. Pull on this handle bar
and so tilt the device slightly backwards so that at the front the unit is standing
approximately 150 mm clear of the floor.
• While holding the unit in this position, a second employee screws the steering
castors (front wheels) from below into the existing threaded sleeves, using the
pre-assembled screws.
The threaded sleeves can be found in the unit's base plate in the front corners
of the unit. The front wheels are now mounted on the unit.
• Now slowly lower the unit again at the front and lock the brakes on the two
front wheels.
• Now grasp the handlebar and lift the unit somewhat, so that the unit is raised
at the back roughly 150mm above the ground. The second employee can now
screw the large rear wheels (with their preassembled axles) from the side into
the threaded sleeves located there
• The last step is to push the two caps onto the rear wheels you have just
assembled.
Art. No.: 150 2220
Technical changes and errors excepted.
KEMPER SmartMaster Operating Instructions - EN
- 46 - Rev.: 7
Latest update:
02/2015