Use; Qualification Of Operators; Operator's Controls - Kemper SmartMaster Manual De Uso

6 Use

Every person who is concerned with the operation, maintenance or repair of the
SmartMaster must have completely read and understood these operating
instructions.

6.1 Qualification of operators

The end-user of the SmartMaster may only entrust the use of the device on their own
to persons who are familiar with the task.
Being familiar with this task includes the fact that the persons concerned have been
instructed according to the task to be performed and understand the operating
instructions and the relevant works' operating instructions.
Only permit use of the SmartMaster by trained or instructed staff. This is the only way
to a achieve awareness among all employees concerning safety and hazards at
work.

6.2 Operator's controls

On the front panel of the Smart Master there are the following four components, one
below the other:
Device switch I / 0
-
This is the switch to turn the device on and off. It is thermally protected and
also acts to protect the motor against overload. If any foreign object enters the
fan impeller and blocks it, this switch returns automatically after a few seconds
to the "0" position and thus prevents the motor burning out.
- Operating control lamp
The green light indicates that the device is in operation and running normally.
If extraction performance falls below minimum or the device switches back to
"0" position because of overloading, the green light goes out.
Proceed with welding work only if the green operating control lamp is lit.
Operating hours counter
-
The operating hours counter runs at the same time as the fan motor. It allows
you to gather information about the SmartMaster's operating hours and also to
monitor the service life of the filters. This way the replacement filters can be
ordered in time to change them.
Art. No.: 150 2220
Technical changes and errors excepted.
KEMPER SmartMaster Operating Instructions - EN
- 49 - Rev.: 7
Latest update:
02/2015