Meanings Of Symbols - Tanaka TCH 24EAP Instrucciones De Manejo

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning before use.
Hedge Trimmer
It is important that you read, fully understand
and observe the following safety precautions
and warnings. Careless or improper use of the
unit may cause serious or fatal injury.
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Always wear eye, head and ear protectors
when using this unit.
Never touch the cutting blade when it is
running.
Choke – Run position (Open)
Choke – Start position (Closed)
On/Start
Off /Stop
Emergency stop
Fuel and oil mixture
Idle speed adjustment
Priming pump
Hot Surface – Contact with hot surface can
cause serious burns.
Lubrication should be applied at 20 hour
intervals and more frequent at heavy use.
Guaranteed sound power level
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is correctly assembled and adjusted.
• Start the unit and check the carburetor adjustment. See "MAINTENANCE".
NOTE: Equivalent noise level / vibration level are calculated as the time-weighted energy total for noise / vibration levels
under various working conditions with the following time distribution:
* 1/5 Idle, 4/5 racing.
(Original instructions)
Displacement
Spark plug
Idling speed
Idle
Fuel tank capacity
Dry weight (without fuel and blade case)
Blade type
L
Overall blade length
P
Blade pitch
Gear ratio
L
Sound pressure level LpA by ISO 10517
pA, eq
Equivalent*
ISO10517
L
Sound power level LwA by ISO 10517
WA, eq
Equivalent*
ISO10517
Measured sound power level LwA by 2000/14/
L
WA, Ra(M)
EC
2000/14/EC
Racing
Guranteed sound power level LwA by 2000/14/
L
WA, Ra(G)
EC
2000/14/EC
Racing
Vibration level by ISO 10517
a
hv, eq(F)
Front handle / Equivalent*
Vibration level by ISO 10517
a
hv, eq(R)
Rear handle / Equivalent*
K
Uncertainty
5
English