Checks And Adjustments - Honda HF2315 Manual Del Operador

6.2.2 Rear axle
This is a sealed single unit which does not require maintenance. It
is permanently lubricated and this lubricant does not need changing
or topping up.
6.2.3 Battery
To ensure long life to the battery it is es-
sential to keep it carefully maintained.
The machine battery must always be
charged:
– before using the machine for the first
time after purchase ( 3.1);
– before leaving the machine for a
prolonged period of disuse;
– before starting up the machine af-
ter a prolonged period of disuse.
The machine has a connector (1)
for recharging, to be connected to
the corresponding connector of the
maintenance battery-charger.
IMPORTANT
No device other
than the battery charger is to be connected to this connector.
During periods when it is not used, the charge level can be kept
constant by using the maintenance battery charger supplied.
IMPORTANT
The charge must be maintained with the battery
charger, following the instructions given in the charger booklet.
Other recharging systems may definitively damage the battery.
A low battery must be recharged as soon as possible. Otherwise,
irreparable damage could be done to the battery's elements.
Periodically check the electrolyte level. When topping off, use ONLY
distilled water for batteries.

6.3 CHECKS AND ADJUSTMENTS

6.3.1 Removing, replacing and rebalancing of cutting means
A badly sharpened cutting means pulls out the grass, reduces the
loading capacity and causes the lawn to turn yellow.
IMPORTANT
To access the cutting means, remove the cutting-
means assembly using a quick release system that allows easy
removal from the machine.
a) Removing the cutting-means assembly
Remove the side guards before
removing the cutting-means as-
sembly. ( 5.4.12)
HF2315 ••
◊
After moving the cutting height
lever to position «1», loosen the
engagement cable adjuster (1),
pull it out and release the spring
(2).
Free the cutting means belt (6)
from the clutch pulley (7).
Release the two cotter pins (8)
which hold the two rods (9) onto
the frame.
Release the three cotter pins
(10) holding the pins onto the
lifting lever, being careful not
to touch the nuts or locknuts in
order to keep them parallel for
assembly.
Having checked that there is
nothing in the way, the cutting-
means assembly can be re-
moved, turning it anti-clockwise
so that all the pins come out of
their positions.
To assemble, perform the operations described above in reverse
order making sure that the front end of the discharge chute is
positioned correctly in relation to the cutting-means assembly
opening.
HF2417HM• HF2417HT• HF2622H♦•
Remove the "Mulching cable".
Remove the pin (1) and extract
the ring (2). Loose the nut (3)
and remove the cable (4).
HF24•• •• HF26••
◊
Put the cutting height adjustment
lever into the notch at position
«1».
Release the cutting means en-
gagement spring (1).
Loosen the register (2) and ex-
tract it from the seat.
Free the cutting means belt (4)
from the clutch pulley (5).
HF24•• ••
◊
Remove the two cotter pins (6)
from the two front connecting
rod pins (7), without loosening
or changing the position of the
nuts (8) and locknuts (9).
Remove the two split-pins (10)
of the rear pins. Then check
that there are no obstructions
and remove the cutting-means assembly,
pulling it out so that all the pins come out
of place.
1
3
2
••
◊
1
4
2
10
19 EN