Corghi CompactLine Serie Manual De Uso página 94

In ALU 1P the balancing plane is about 15mm further back (weight centre line) than the point
where the measuring head touches the rim (Fig.15/15a).
In ALU 2P refer to the rim edge, since the inner weight is of the traditional clip type (Fig. 12).
Pay maximum attention when the end of the arm is being placed in an area of the rim free
of discontinuity, so that the weight can be applied in that position.
- Keep the arm in position. After two seconds the machine emits an acoustic confirmation
signal to indicate that the distance and diameter values have been acquired.
- Move the end of the automatic measuring arm in correspondence with the plane selected
for the application of the outside balancing weight (Fig. 16/16a), in the same manner as
described previously for the inner side.
- Keep the arm in position and wait for the acoustic confirmation signal.
- Return the measuring arm to the rest position. Automatically the machine will set up in
the ALUP balancing programmes (FSP programme).
- Perform a spin.
- At the end of the spin, if you want to change the balancing programme set automatically
by the machine (FSP), select the balancing programme icon
button until the required programme is selected.
Applying balancing weights. (Fig. 17)
• Adhesive weights applied with the weight-holder device (if provided) and after modify-
ing the application position from 12 o'clock to CLIP in the "Adhesive Weight Application
Position" set-up menu.
- Select the plane where the first balancing weight is to be applied.
- Rotate the wheel until the central element of the corresponding position indicator lights
up.
If the weight to be applied is a conventional clip type (inner side in Alu 2P), apply it on
the corresponding 12 o'clock position. If the weight to be applied is instead the adhesive
type and the weight-holder device is installed, proceed as follows:
- Centre it inside the cavity of the weight-holder terminal of the measuring arm (Fig.17 a,
b), with the backing paper of the adhesive strip facing up. Remove the protection (Fig.
17c) and turn the terminal so that the adhesive faces the internal surface of the rim.
- Move the sensor until the two reference lines (green in colour) coincide in the relevant
windows on the screen.
- Turn the end of the measuring arm until the weight adhesive strip is in line with the rim
surface.
- Press the button (Fig.17d) to eject the weight and make it stick to the rim.
- Return the measuring arm to the rest position (Fig.17e).
94 Operator's manual EM 9280 - EM 9280 C CompactLine
and press the ENTER