Shutting Down; Using The Automatic Wheel Clamping System C - Corghi EYE LIGHT Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

-
enabling the WM programme.

SHUTTING DOWN

This function starts the shutdown process which
protects the Windows operating system installed
on the PC and depowers the machine.
Proceed as follows:
-
Press the Enter button
-
Wait for the PC to be turned off completely
as confirmed by an intermittent beep.
-
finally, press the switch located on the left
side of the casing (B, fig.11b).
USING THE AUTOMATIC
WHEEL CLAMPING
SYSTEM C
NOTE:
After every power on, the first time the automatic
wheel clamping system is activated using the
pedal, the machine will perform a calibration by
automatically moving the two ratchets located on
the hub towards the outer side. When calibration
is complete, the operator can use the machine
as described below.
Wheel locking procedure with the automatic C:
Centring with cone at front
-
Fit the wheel on the shaft, sliding it into place
until it rests against the flange.
-
Fit the most suitable cone on the shaft and
insert it into the central hole of the wheel.
-
Fit the locking device by making it slide on
the hub until it comes into contact with the
cone.
-
Press the control pedal for at least one second.
Centring with cone at rear
-
Fit the most suitable cone for the central hole
of the wheel on the shaft.
EYE LIGHT - Operator's manual
-
-
-
-
Wheel release
-
Centring with flanges
C hub removal
-
.
-
- Unscrew the C hub completely.
- Mount the flange on the shaft and lock it with the
two screws (A, Fig. 13) using the CH 6 wrench.
Fit the wheel onto the cone, sliding it into
place until the cone comes into contact with
the plate that holds the spring.
Apply the protective cap to the sleeve.
Fit the locking device by making it slide on
the hub until it comes into contact with the
wheel.
Press the control pedal for at least one second.
Press the control pedal for at least one second
to release the wheel from the flange.
Hold down the stop
the keypad for at least 3 seconds or go to
the utility and configuration programmes,
then press the icon
wheel-holder shaft and the internal devices.
Insert the C special key provided with the
machine in the C hub hole (Fig. 12).
button on
to block the
UK
12
57

Publicidad

Tabla de contenido
loading

Tabla de contenido