Corghi EYE LIGHT Manual De Uso página 70

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

E: vertical axis of the ordinates that indicates
the radius with respect to the shaft assembly
axis;
F: cursor for icon profile graphic zoom
: reset graphic factory settings.
4. UNBALANCE OPTIMISATION
This procedure reduces the total wheel unbal-
ance by compensating for the tyre unbalance
with the rim unbalance, if possible.
The machine indicates that the procedure needs
to be performed by displaying the following warn-
ing light
to perform the procedure whenever considered
necessary.
The calculations performed by this programme
are based on the unbalance values measured dur-
ing the last spin performed which must therefore
refer to the wheel being serviced.
OPT 1
-
Move the valve to the 12 o'clock position.
-
press the button
on the monitor to confirm the operation;
OPT 2
-
Place the wheel in the 6 o'clock position as
indicated on the screen. If the RPA function
is enabled, the wheel is automatically placed
in position.
-
Mark the 12 o'clock position on the outer side
of the tyre.
-
press the button
on the monitor to confirm the operation;
OPT 3
-
Remove the wheel from the wheel balancer
and using the tyre changer, line up the mark
on the tyre with the valve.
-
Remount the wheel on the wheel balancer.
-
press the button
on the monitor to confirm the operation;
70
. The operator can decide
or the button
or the button
or the button
OPT 4
-
Move the valve to the 12 o'clock position.
-
press the button
on the monitor to confirm the operation;
OPT 5
-
Perform a spin by lowering the guard.
If significant improvements cannot be obtained,
the message "OUT" is displayed at the end of the
spin. In this case, we recommend quitting the
procedure by pressing the Exit button
The operator can decide to continue by press-
ing the button
the monitor.
OPT 6
Now, the real unbalance values of the wheel as it
is mounted on the wheel balancer are displayed.
-
Place the wheel in the position indicated on
the screen. If the RPA function is enabled, the
wheel is automatically placed in position.
-
The unbalances and percentual improvement
which can be obtained if the user decides to
continue the optimisation procedure appear
in the window.
If the improvement is considered insufficient,
press the Exit button
-
Make a double mark of the tyre in 12 o'clock
on the outer side position if direction in
which the tyre is fitted on the rim is not
pointed out, on the inner side position if the
direction is pointed out. If you do not wish
to invert the direction, press the Enable/
disable tyre inversion button
-
press the button
on the monitor to confirm the operation;
OPT 7
-
Remove the wheel from the wheel balan-cer.
-
Rotate the tyre (inverting if necessary) on the
rim until the double chalk mark lines up with
the valve.
EYE LIGHT - Operator's manual
or the button
or the button
on
.
or the button
.

Publicidad

Tabla de contenido
loading

Tabla de contenido