Corghi EYE LIGHT Manual De Uso página 66

using the keypad.
- Press the Exit
the manual data setting.
Note: When dimensions are set manually, clip
or adhesive weights must be applied manually
in the 12 o'clock position.
3. Suite WHEEL DIAGNOSIS PROGRAMME
3.1. Radial and lateral runout measurement
This function is used to determine the causes of
disturbance (vibration) generated by geometric
deformation of the rim and/or tyre, which may still
persist even after a thorough balancing procedure.
The machine indicates that the procedure needs
to be performed by displaying the following war-
ning light
to perform the procedure whenever considered
necessary.
To do this, perform a spin.
If a wheel assembly is mounted, the following
icons are displayed on the screen at the end of
the spin indicating:
-
the radial run-out of the wheel (1st harmonic);
-
the radial run-out of the wheel peak-to-peak;
-
the lateral run-out of the wheel (1st harmonic);
-
the lateral run-out of the wheel peak-to-peak;
66
button to terminate
. The operator can decide
-
the radial run-out of the rim (1st harmonic);
-
the radial run-out of the rim peak-to-peak;
-
the radial run-out of the tyre (1st harmonic);
-
the radial run-out of the tyre peak-to-peak;
- the wave forms show the progress of the wheel
runout.
If a rim is mounted, the following icons are di-
splayed at the end of the spin indicating:-
the radial run-out of the inner tyre bead (1
harmonic);
-
the radial run-out of the inner tyre bead
(peak-peak);
EYE LIGHT - Operator's manual
st